Electronics Bay
Note
The electronics bay provides space to contain your machine's electronics. Due to the unique nature of each machine setup and electronics choices, this manual will not attempt to guide you through the fitting or wiring of your electronics. This manual will focus on installing the front and rear I/O panels, cable entries, cable guides, and DIN rail mounts.
Cable Management and DIN Rails
Components Required
3 x Wire duct 45 x 60
VFB Tape
Components Required
2 x DIN Rail 800 mm
2 x DIN Rail Enclosure Mount B
Components Required
VFB Tape
Components Required
4 x DIN Rail Enclosure Mount A
Components Required
8 x M3 x 10 SHCS
Passthrough and Base Board
Components Required
4 x Passthrough Plug
2 x Electronics Bay Passthrough
Make sure to add weather stripping to the panel.
Components Required
1 x Panel 150 x 710
Weather Stripping
Components Required
8 x M3 x 10 SHCS
Front and Rear IO Panels
Components Required
1 x Front Switch Cover
1 x E-Stop Button
2 x Rocker Switch
Components Required
1 x Rear Inlet Cover
1 x M3 x 3 Heatset Insert
Components Required
1 x IEC Power Inlet
1 x 120 mm Fan
3 x M3 x 30 BHCS
Components Required
1 x Front Switch Cover
1 x Front Mid Cover
1 x Front Inlet Cover
12 x M3 x 10 SHCS
Components Required
1 x Rear Inlet Cover
1 x Rear Mid Cover
1 x Rear Lower Cover
12 x M3 x 10 SHCS
